Forum Skoda Superb

Adam091 pisze: ↑1 lip 2020, o 13:42 Co to może byc
? Skoda superb 2 2011r 2.0 diesel. Kod błędu P023700 miła ktoś coś takiego? Mruga spirala auto nie ma mocy jest w trybie awaryjnym

bear84waw pisze:Cześć, może ktoś polecić miejsce gdzie w miarę bezpiecznie kupić VCDSa ?
Na chwilę obecną jestem strasznie zielony w tym temacie i nie chciałbym umoczyć kasy.
Rzuciłem okiem na olx i znalazłem coś takiego:
https://www.olx.pl/oferta/pelna-wersja- ... 4;promoted

grzesiu26 pisze: ↑11 lip 2013, o 11:55 Masz jeszcze to. Na pewno Ci pomoże (źródło: http://www.briskoda.net/forums/topic/27 ... the-cabin/)

I finally had some time to play with VCDS on my new Superb.

I know some of you (especially the Taxi-ists) have been asking if the button next to the gear stick can be used to close the door. By default, it does not, however with a simple VCDS change it can.


You will need:
- VCDS cable with a valid license and a computer


1. Connect VCDS cable and turn on ignition. Do not start car. Open VCDS and select address "6D-Trunk Electronics":



2. Select "Security Access":


3. Enter the secret magic password "12345" and click "Do It":


"Dark Helmet: So the combination is... one, two, three, four, five? That's the stupidest combination I've ever heard in my life! That's the kind of thing an idiot would have on his luggage!"


4. Success!



5. Select Adaptation and then select the relevant channel (highlighted below). Choose "Activate" and then select "Do it".



6. You may also wish to turn off the beeper. You can do it one of two ways.
Option 1: Select "Volume of warning signal in automatic operation" and choose "Not active" . Note it's not actually a volume, just an on/off.
Option 2: Select long coding, then clear the option "Tone Generator Installed"

Notes:
- There are a few other things you can do in adaption like change the pitch of the warning tone (default is 1000Hz) and the duration of each 'beep" (default is 0.5 seconds
- You can also enable closing the door by the keyfob, see the picture in part 5 above and the rest is obvious
- Note on the two options: "Touch function for closing" requires you to hold in the button until the door is closed. If you release the button the door motion will stop. "Tap function for closing" just needs a single push on the button to close the door. I'm not sure what happens if you activate both options as I didn't try it.